Beneteau 40 & 43 Discussions (347)
| Discussions | Replies | Latest Activity |
|---|---|---|
Bow Plate-Gennaker CodeI have a 2012 B37. I have installed a Banmar Roller Gen Code 08 last summer-works great. I am concerned that the tach line is attached to t… Started by Vince Arsenault |
6 |
Jan 2, 2013 Reply by Mike Mollison |
cutlass bearing, shaft alignmentCutlass bearing on my 2010 B40 is worn. Previous owner replaced one last year so it's clear that I have an engine alignment problem. I hav… Started by Greg Donnelly |
7 |
Dec 7, 2012 Reply by Robert & Sandy |
Beneteau 40 fuel level sensorMy fuel gauge shows that my tank is full when I know that it is not. The electronic gauge shows that I it is monitoring tank #2 when I only… Started by William Dill |
8 |
Oct 6, 2012 Reply by Will Papke |
cushion / uholstery damageOn our 2008 vintage boat all of the bottom seat cushions in the main cabin have started to flake off and showing severe wear. The material… Started by sam |
1 |
Sep 23, 2012 Reply by Greg Donnelly |
Battery Charging IssuesI am unhappy about the time it takes to charge the batteries and the drain from the refrigerator/freezer units on my B40 #247. I have the 5… Started by GaryG |
7 |
Sep 10, 2012 Reply by Mike Brown |
Boom Car BindingAnyone had an issue with the boom car on the roller furling mast binding and not allowing full unfurling of the mainsail? It's occured befo… Started by Mike Brown |
6 |
Sep 4, 2012 Reply by Mike Brown |
I recommend B43 owners to check their fridge interior lightsAfter 4 years, I found out that the magnet inside the door was misplaced (About 2 cm below its appropriate position) and did never turn off… Started by Vedat Midilli |
8 |
Sep 4, 2012 Reply by Alain Brauckmann |
Changed out Jabsco leaking toiletSuccess! I finally solved my constantly back-flowing issue with the !#@$%!!!! Quiet Flush electric toilet. I changed out numerous joker val… Started by sam |
2 |
Sep 4, 2012 Reply by Alain Brauckmann |
Yanmar tachometerHello, I noticed that the Yanmar tachometer sometimes gets irrealistic readings. I guess it's a false contact somewhere. After this it we… Started by foster |
2 |
Sep 3, 2012 Reply by foster |
outboard engine mountI've recently purchased an outboard motor for my dinghy. I mounted the 8 horsepower Honda four-stroke engine on the port-hand side of the… Started by Alan |
3 |
Aug 28, 2012 Reply by Jeff Shukis |
Latest Activity
"Hi All,
french built 2010 43 has been very dry down below but now a slow leak has occurred which is showing at the limber holes under the floor board in forward cabin. Bilge pump goes every 3hrs for 20secs. Not sure if it’s fresh/rain water or…"
Do you dream about offshore cruising?
"hello
been years since on site.
im having trouble changing my heading. are we limited to words?
is there an instruction page?
Thank you
lola"
© 2025 Created by CAN DRAC.
Powered by
