SeaKnots

A moment ago I was reading on another forum about a blower motor not working on a Beneteau 361 and then it occurred to me that I've never seen the engine compartment blower on my B40. If anyone here knows would you please enlighten me on it's location?

Thanks,

Wayne

Views: 98

Replies to This Discussion

The engine compartment exhaust blower is located on the port side behind the vent. You have to remove the propane locker to access it. To remove the propane locker you have to crawl into the rope locker below it and remove the hose that’s installed to exhaust any leaking propane. Don’t forget to reinstall it. The fuse for the fan is 10 amp and is located in the right hand side of the battery compartment. They also use the fuse for power to battery isolators. 
I hope this helps. 
Mike

Thanks for the info Mike. Now I need to verify it works. I know it gets extremely hot in the engine compartment after a while. 

Wayne, my never ran. I discovered the issue when the fuse blew. I then foolishly bought a new fan and installed it only to have it sound like a helicopter in the cockpit. I cushioned it and tightened it to no avail. I finally disconnected it without any issues. 
Mike

RSS

Latest Activity

Henri left a comment for Ron Manicom
"Ron, Henri from Vydec here. call me 703-314-6304. Hope all is well with you. Henri."
yesterday
Henri left a comment for Ron Manicom
"Ron, Henri from Vydec, remember ? call me 703-314-6304. Hope all is well. Henri."
yesterday
Mike Brown commented on CAN DRAC's group Beneteau 40 & 43
"Robert glad to hear you go the problem solved. mike"
Oct 11
Robert & Sandy commented on CAN DRAC's group Beneteau 40 & 43
"Thanks for all your comments my friends at Seaknots. The halyard has been rerun without passing through the small stainless steel eye, as seen easily in the pic provided by Chris on 17th August. All furling now takes place without any undue effort,…"
Oct 11
Mike Brown replied to Jochen Vetterlein's discussion O43: Good tracking on starboard side - poor on port side in the group Beneteau 40 & 43
"Well at least you’ve narrowed it down to the Genoa. I doubt here’s any issue with the hull or running gear. Nor do I think the slight list you have will have an impact either as many boats have the same based on how full the water and or…"
Oct 9
Jochen Vetterlein replied to Jochen Vetterlein's discussion O43: Good tracking on starboard side - poor on port side in the group Beneteau 40 & 43
"In the meanwhile, I performed some sailing tests trying to be as impartial as possible. I was sailing close hauled on the starboard and port side. I used the autopilot steering the boat at 37 degrees to the apparent wind. Apparent wind was 12 to 19…"
Oct 9
James Taylor replied to Jochen Vetterlein's discussion O43: Good tracking on starboard side - poor on port side in the group Beneteau 40 & 43
"Sounds like your rigging may be in need of tuning????? (Owned B43#19 for 10 years), Sailed from Mass to Tampa to Bahamas with it, great boat, no major issues at all. Boat has flat bottom basically so no need to put rails in water. I found it a very…"
Oct 9
Mike Brown replied to Jochen Vetterlein's discussion O43: Good tracking on starboard side - poor on port side in the group Beneteau 40 & 43
"I’d also do a test using only the main. The more testing you do the more likely you’ll find the problem. I’d also check to see how much the leeward shrouds sag during all the tests. Let us know what you find. Good luck Mike"
Sep 27
ADVERTISE ON SEAKNOTS CONTACT US AT: 
candrac@sailforwater.com

© 2021   Created by CAN DRAC.   Powered by

Badges  |  Report an Issue  |  Terms of Service