Andrea nice boat!
Not to be critical here but to show the other gals about sail trim. If you notice that your jib is luffing around because the mainsail is blocking the wind to the jib due to the wind coming DDW (dead downwind). The the two outer boats do not have their jibs rolled out. You do, which is fine but you need to do a few things to get it to fly.
#1 is to pole it out with a whisker pole. Can be a pain to set if short handed in crew.
#2 is twist the mainsail, like the the outer boats have. From the pictures you can see the bottom 1/3 of the mainsail moved to leeward puts a twist into the sail. This is done with the traveller. How do it is this.
a. Tighten vang.
b. Release Cunningham and down haul (creates belly) Most boats don't seem to have these unless you race or small sailboat under 30'
c. With the traveller and boom center tighten up the outhaul to near taught..
d. Move traveller to full windward (down) position.
c. Ease mainsheet until top 2/3 of mainsail is up against the spreaders, ( I personally don't like my sails against the spreaders due to chaff. This is personal preference)
d. Move traveller to around 1/2 to 3/4 leeward (up) position until desired twist is achieved.
What this does is open up a slot for the wind to get to the lower 2/3 of the jib especially if it is low cut (the foot of the sail is close to the lifelines at the clew). You will see that Andrea's top 1/3 is flying and the lower 2/3 is not. Another way to get the jib to fly especially if you have a 130-150 jib is to reef in or roll in the mainsail enough to fill the the jib. I usually find about first reef or about 1/3 on a rolling furling does the trick.
The other thing is make sure your jib car is all the way forward. This technique is only if going DDW +/- 15 degrees.
Hope this helps.
"Wayne, yes I'm still out here. She's looking good and you'll love her. The 38.1 is a perfect size for 2 people with occasional guest (s). Plus she's a sweet sailing boat. I'll attach a short video of one I was delivering…"
"Sam, I am just in the process of replacing both of my eyebrow windows. I have the new ones from Beneteau and am talking with dealer in Florida re Bebeteaus advice. It would be helpful to talk to you about your experience. I have never seen…"
Good morning gang,I have received both port and starboard cabin windows from Beneteau for replacement as the existing leak and are badly etched. Beneteau has referred me to the dealership for installation but I'm having trouble getting a response. Does anyone have any experience replacing these and any recommendations. JohnSee More
"Hello Randy,
New to the group, going through the posts, I have come upon this thread. I was considering tinting my windows of my Beneteau 43 with a darker tint, but I really like your idea. So I will copy with…"