I own my own boat, just not able to sail her. Whats that you say.
thats right I used to sail out on many weekend trips. Week long
trips. My x was the Captain, I was the cook and bottle washer. I just love being on the water. wish I could meet someone in y area who could take me Sea Castle out for a sale, and not have to pay an Instructor to take me .
I n the past Florida, Monhegan Ils. Maine. All along the coast of Maine. New Hamshire Ils. O f Shoals.
Comment Wall (1 comment)
You need to be a member of SeaKnots to add comments!
"Mike is correct. The is a vertical pin in the middle of the winch handle hole that pushed down and disengages the electric motor on the winch. Also, on my Oceanis 45, there is a circlip that holds the top on. I don't remember if the 40 electric…"
"Thanks Mike. I did use a light hammer but I do have heavier ones at work and I did use WD40. As for a disengagement pin, I didn't see one when I looked down in the top of the winch. I did see a small circular pattern in the bottom that I…"
"Thanks Mike, however I have tightened both attachments and if you grab the track in the middle you can move it side to side making the noise. I took it apart, slid the track forward to add tape to both side of the boom, than careful slid the track…"
"Frank your comment didn't show up in the discussions on the 40/43 site. It's simply a comment on your page. Not sure if others will see it. For what it's worth I don't have the problem on our boat. There are two pieces of…"
"I can't imagine anything in the winch top that would bend. Other than the electric drive and a disengagement pin that activates when the winch handle is inserted the winch is the same as the others. It sounds like the collar is jammed due to…"
Took care of the lint build up on the fridge condensers and the leaky shower sump this weekend. Then went to the electric cabin top winch to disassemble, clean and lube only to find the top cap wouldn't unscrew. It should have by light tapping with a screwdriver but to no avail.So I stepped it up a notch with a brass drift and screwdriver and again, no go. I then tried a steel drift and the cap never moved in the slightest. It is as if it was secured with permanent Lock Tite.Now when I say its…See More