I added a post on the racks. Or maybe I didn't? At any rate the racks in our fridge are tapered at the rear and fall out whenever you pull them out more than 1/3 of the way. Makes getting to the back of the rack a PITA. Before I start modifying the racks I thought I'd see if anyone else has the problem and is so how did you fix it?
Permalink Reply by sam on April 29, 2010 at 10:57am
yep, the racks do tilt out of the side slots when you pull them forward. I have not given any thought on how to modify and would like to see what you come up with.
They're tapered towards the back which I'm sure was done to make it easier to insert them. Unfortunately it also makes it easier for them to fall out. Think I'll try reshaping the outer sections. May also mark the outer most point where they remain stable. Then just keep an eye on the mark when we're pulling the drawer out. I'll let you know what seems to work.
"Hi All,
french built 2010 43 has been very dry down below but now a slow leak has occurred which is showing at the limber holes under the floor board in forward cabin. Bilge pump goes every 3hrs for 20secs. Not sure if it’s fresh/rain water or…"