SeaKnots

The starboard side of my Traveller is starting to lift up. I am guessing to remove the center 5mm Allen bolt that goes through the middle of the sheeves, although I cannot get it to budge, to access it. Does anyone have any experience with this??

Thanks Dave 

B43 Shore's Adrift

Views: 64

Replies to This Discussion

I had to replace my sheeve on both sides and really struggled to get the bolts out. Once I had them out, each was bent thus the challenge. I ended up stripping one or two of the hex bolts and used an angle grinder to square off the head of the bolt to allow me to get more torque on the bolts which eventually came out.  

Took a lot of work and was a bit scary, but just know the reason you are having difficulty getting them out is likely due to them being bent from accidental gybes or other 'crashes' from having one of the cleats unlocked during a tack (sounds like i may have experience with unlocked sheets!).

RSS

Latest Activity

Brandon P is now a member of SeaKnots
Friday
Pankaj Tripathi is now a member of SeaKnots
Mar 19
Anna Kokou updated their profile
Mar 8
Profile IconDo My Assignment, William Noah, Thinq Proto and 4 more joined SeaKnots
Mar 7
Michael Boyle commented on CAN DRAC's group Beneteau 40 & 43
"Hi All, french built 2010 43 has been very dry down below but now a slow leak has occurred which is showing at the limber holes under the floor board in forward cabin. Bilge pump goes every 3hrs for 20secs. Not sure if it’s fresh/rain water or…"
Feb 28
LOLA commented on Franc's video
Thumbnail

Do you dream about offshore cruising?

"hello been years since on site. im having trouble changing my heading. are we limited to words? is there an instruction page? Thank you lola"
Jan 23
Filling Machine updated their profile
Dec 27, 2024
Packaging Machinery updated their profile
Dec 24, 2024
ADVERTISE ON SEAKNOTS CONTACT US AT: 
candrac@sailforwater.com

© 2025   Created by CAN DRAC.   Powered by

Badges  |  Report an Issue  |  Terms of Service