SeaKnots

Hey folks

has anyone had there anchor motor just stop working? I use to get some clicking with the controller but at the end of last season it just stopped. I did notice a very very thin black broken wire underneath it.

Views: 303

Replies to This Discussion

I'll have to check it out. The relay that controls the up/down on ours is mounted on the side of the engine. I had to replace it for intermittent won't raise the anchor.
Michael,
We had the same trouble and it turned out to be the circuit breaker/swwitch in the aft cabin adjacent to the batteries.
Initially it went high resistance so it showed 12.7 volts but would not carry the current required then it went open circuit completely. New breaker/switch and all good.
When we purchased the yacht a chain counter had been fitted though Beneteau failed to fit the sensor and subsequent wiring...all fixed and working well.
Good luck,
Bilgolabands

RSS

Latest Activity

James Taylor replied to Chris's discussion Battery Charger in the group Beneteau 40 & 43
"All great advice! Did you check the charger's "battery type" selector switch position (flood,gel,agm)? Our Dekka agm's ( 396ah house and 98ah engine) gave us over 7 1/2 years of usage before replacement. The batteries were still…"
yesterday
Mike Brown replied to sam's discussion Teak seat metal protrusions in the group Beneteau 40 & 43
"Sam, I have not seen anything like that on my or others 40/43s. I don't understand why they would even do such a thing considering there's no other material they could drive a brad into. Grinding the tops off flush sounds like the right…"
yesterday
Mike Brown replied to Wayne's discussion Anchor upgrade in the group Beneteau 40 & 43
"Peter, I've also lost the scupper covers. I installed rubber pipe insulation over each side of the bridle and it works well in keeping the bridle from rubbing on the covers. . They'll need to be replaced periodically as they'll get…"
yesterday
Arne Opperud replied to sam's discussion Teak seat metal protrusions in the group Beneteau 40 & 43
"I have used Boracol treatment once or twice a year. Keeps the black spots away, maintaining a grey patina.      "
yesterday
Arne Opperud replied to Dave Shore's discussion B43 wheel leather in the group Beneteau 40 & 43
"I have used mid tan shoe polish, cream type. Worked well."
yesterday
sam replied to Wayne's discussion Anchor upgrade in the group Beneteau 40 & 43
"Yep, I too have snapped a couple of the clam shell drain covers off. I have a couple of spares, but may or may not replace this time. The slack didn't seem to be the ultimate cause. Seems that wind/tide shifts and wake surge would cause the…"
yesterday
Peter Obetz replied to Wayne's discussion Anchor upgrade in the group Beneteau 40 & 43
"Sam, we are the essentially the same.  Using the same mantus bridle as you.  Quick question to you and any others using a bridle.  We had the bridle rubbing the sides of the bow in a recent storm and it ended up snapping off the…"
yesterday
sam replied to Wayne's discussion Anchor upgrade in the group Beneteau 40 & 43
"On Longhawk we use a Rocna 20KG. I changed out the chain gypsy when new to one that handles 5/16 high Test chain. Then I went with 175 ft of 5/16 HT chain tailed with 200 ft of three strand.(overkill, but I had the rode as supplied new). For a short…"
yesterday
ADVERTISE ON SEAKNOTS CONTACT US AT: 
candrac@sailforwater.com

© 2017   Created by CAN DRAC.   Powered by

Badges  |  Report an Issue  |  Terms of Service