Adler Barbour Evaporator 6"x10"x11"
I need an Adler Barbour R12 evaporator box 6"x10"x11" to replace mine. I punctured it! The compressor (Danfoss Cold Machine) was working fine. It lost all pressure, so I will have to refill and pull a vacume. I have researched epoxy and/or brazing repair as an option, but have been told that doesn't work well. So, I am hoping to locate a used unit to reconnect to my compressor. Any possibilities and/or suggestions from any similar experiences would be appreciated.
- Attachments:
-
-
68427701813_0_SM.jpg, 2 KB -
22645701813_0_SM.jpg, 3 KB
-
Replies to This Discussion
-
Permalink Reply by Randy on
-
Here is a tip for everyone that did what I did with a knife as I punctured the evaporator on our Catalina 36 5 years ago and is still working today, The evap is very thin aluminum and will not take heat or silver solder cuz it will just melt the evap. What you can do is go to Grainger supply and get what is called RED EPOXY if they still carry it, it is made just for this, It is heat activated.
Here is a link to what I used and explains it more in detail.
http://www.highsidechem.com/redepxy.html
Randy Sherwood
- ‹ Previous
- 1
- 2
- Next ›
Latest Activity
"Hi All,
french built 2010 43 has been very dry down below but now a slow leak has occurred which is showing at the limber holes under the floor board in forward cabin. Bilge pump goes every 3hrs for 20secs. Not sure if it’s fresh/rain water or…"
Do you dream about offshore cruising?
"hello
been years since on site.
im having trouble changing my heading. are we limited to words?
is there an instruction page?
Thank you
lola"
© 2025 Created by CAN DRAC.
Powered by
