SeaKnots

I am installing a NextGen 5.5kw generator in my 2011 B-40 - 2 cabin. I started installation and decided the best location is the cockpit locker approximately 12 inches from the forward bulkhead. To accommodate the height of the generator I will need to cur out a portion of the shelving in the locker.

Has anyone installed a generator in their B 40/43 and any time saving suggestions.

Thanks,

Bruce

 

Views: 1609

Replies to This Discussion

I am attaching the spec sheet for the generator that I put in my Ben 40. It is very compact and specs say it weighs less than 300 lbs. with the sound shield. There are others that have installed the 5.5 in their starboard aft hatch as well. There is also a 3.5 kw version that will drive AC, but not necessarily all the electrical's on the boat side. If you use it allocating your resources, it might be suitable as well.

Attachments:

I added an opening hatch to the starboard locker to provide fresh air to the generator. I just need to remind myself to open it each time I turn on the gen set. I also sound proofed the starboard bulkhead and forward bulkhead of the cockpit locker as well as put the exhaust fan for the generator on rubber mounts to cut down vibration noise. We added added a set of motor mounts under the ones on the sound shield to further isolate vibration. They are rated at 75 lbs each. I will be adding chain to the chain locker. Currently the boat sits slightly aft down and bilge water does not easily drain to the bilge sump. There is no noticeable heel to starboard.

I added a 3.5 KW Next Gen to my B43-2 cabin.. I too placed in the port locker, running sideways near the front of the compartment under the shelf.I also added the Soft Start controller to the 16kBTU aircon to allow the 3.5 to start . It works fine,

I went with the 3.5 for lower weight, and lower fuel consumption. It is a bit noisy, a little less than the main propulsion engine.

Sam

LONGHAWK

B43, hull #9

Anne is correct. You made need to take apart some of the wider elements to place in the aft locker. There are some owners that went with the 3.5 KW and then manage their energy load to run only AC or House electricity or only one compressor at a time. I installed a 5.5 NextGen and placed it in the cockpit port locker, but I have a 2 cabin Ben 40. 

Bruce

The boat yard installed the generator on my 2008 40' and cut out the panel between the aft cabin and the locker also. They put simple barrel latches on both sides to keep panel in place. The cut is just below the cabin ceiling, allowing easy access to the side of the generator for service. 

wd

I am working with Beneteau to install a 5kw Onan in our Oceanis 43.  Below are photos of the proposed location in the port locker.  Does anyone have experience with this generator in a B40 or B43?  Fischer Panda has been suggested by an after market supplier.  Does anyone have a experience with an FP unit?

Patrick

 

 

Attachments:

It looks like a neat installation. I would suggest that you sound insulate the entire compartment. 

During my investigations before I installed my NextGen 5.5 generator, I read many reviews that panned the Panda and being overpriced and the supply of parts were not readily available.I would be hesitant in installing one.

RSS

Latest Activity

Patrick Findaro posted a discussion

Breathing exercises for period cramps

Breathing exercises have been in practice for ages. They still stand strong with their traditional knowledge and health benefits. These conventional breathing exercises are known to positively influence a person's physical, mental, and emotional state. These breathing exercises during periods can provide relief from physical pain and mental turmoil. Practising…See More
Jan 26
Patrick Findaro posted discussions
Jan 23
LOLA commented on Franc's video
Thumbnail

Do you dream about offshore cruising?

"hello been years since on site. im having trouble changing my heading. are we limited to words? is there an instruction page? Thank you lola"
Jan 23
Patrick Findaro posted discussions
Jan 21
Patrick Findaro posted a discussion

Why Would I Want to Write My Assignment With the Help of a Writer?

 Writing a dissertation is an activity that puts off more than one student, a source of stress and anxiety for some, and total confusion for others. Indeed, this task requires a lot of time to research academic resources, compare available studies, and process and sort data before starting the tedious task of writing and analysis. Without assistance, many students fail to complete this task, which is necessary to validate their degrees.This is how our ‘do my essay’ service comes into play by…See More
Jan 14
Patrick Findaro posted a discussion

How to choose the best assignment helper UK website?

Writing a university essay is no cakewalk. You get bombarded with assignments now and then. As a result, you may get stressed or isolated. Beat the stress with our online assignment maker and get impressive solutions to your assignments written by our experts. A detailed and well-founded dissertation requires a calibrated dive into the sub-disciplines of the doctrine. The student must undertake a painstaking study into the merits and demerits of the discipline. The purpose of university…See More
Jan 12
Filling Machine updated their profile
Dec 27, 2024
Packaging Machinery updated their profile
Dec 24, 2024
ADVERTISE ON SEAKNOTS CONTACT US AT: 
candrac@sailforwater.com

© 2025   Created by CAN DRAC.   Powered by

Badges  |  Report an Issue  |  Terms of Service