SeaKnots

Any recommendations for replacement of the factory headliner around the perimeter of the cabin in the v-berth and aft cabin for the 2008 Oceanis 40 (or similar)? The current vinyl headliner with foam backing is falling leaving black foam residue in it's wake.

Views: 140

Replies to This Discussion

our 2009 B40 vinyl between the rigid ceiling and the hull started falling.  I vacuumed off the old foam.  we had pieces of mylar cover foam for car windshields on board left over from making side light covers.  cut strips wide enough to go from hull to a inch or so over the lip on the cabin liner.  folded vinyl around "stiff" foam and tapped on top.  Slide foam and vinyl back up into gap.  not a permanent fix but a lot better than having the vinyl hanging down.  

Mike

S/V MiJoy

RSS

Latest Activity

Robert & Sandy left a comment for Michael Boyle
"Michael, From experience over three keel boats a fully battened main is almost a requirement. Not only will it make dropping the sail into the boom bag far easier it certainly reduces any flogging and vastly lengthens the life of the sail. While…"
May 16
Brandon P is now a member of SeaKnots
Apr 18
Pankaj Tripathi is now a member of SeaKnots
Mar 19
Anna Kokou updated their profile
Mar 8
Profile IconDo My Assignment, William Noah, Anna Kokou and 4 more joined SeaKnots
Mar 7
Michael Boyle commented on CAN DRAC's group Beneteau 40 & 43
"Hi All, french built 2010 43 has been very dry down below but now a slow leak has occurred which is showing at the limber holes under the floor board in forward cabin. Bilge pump goes every 3hrs for 20secs. Not sure if it’s fresh/rain water or…"
Feb 28
LOLA commented on Franc's video
Thumbnail

Do you dream about offshore cruising?

"hello been years since on site. im having trouble changing my heading. are we limited to words? is there an instruction page? Thank you lola"
Jan 23
Filling Machine updated their profile
Dec 27, 2024
ADVERTISE ON SEAKNOTS CONTACT US AT: 
candrac@sailforwater.com

© 2025   Created by CAN DRAC.   Powered by

Badges  |  Report an Issue  |  Terms of Service