"Michael,
From experience over three keel boats a fully battened main is almost a requirement.
Not only will it make dropping the sail into the boom bag far easier it certainly reduces any flogging and vastly lengthens the life of the sail. While…"
Franc's Discussions (43)
| Discussions Replied To (4) | Replies | Latest Activity |
|---|---|---|
"I went up the mast and installed a block to put the halyard through. Problem solved! "Franc replied Aug 17, 2014 to Spinakker halyard chafe |
10 |
Sep 20, 2014 Reply by Michael Boyle |
"our aft shower drain leaked fresh water into the bilge very early on. beneteau fixed…"Franc replied Apr 9, 2010 to Where the F*** is the water coming into the boat? |
29 |
Aug 20, 2010 Reply by Stephen Hegyesi |
"Thanks, Sam. I have an old gennaker from a previous boat outfitted with a roller fur…"Franc replied Jan 4, 2009 to Roller furling mainsail |
3 |
Jan 4, 2009 Reply by Franc |
"Hey Sam, Ours sometimes gets a little hard to unfurl but so far so good. What was yo…"Franc replied Jan 3, 2009 to Roller furling mainsail |
3 |
Jan 4, 2009 Reply by Franc |
Latest Activity
"Hi All,
french built 2010 43 has been very dry down below but now a slow leak has occurred which is showing at the limber holes under the floor board in forward cabin. Bilge pump goes every 3hrs for 20secs. Not sure if it’s fresh/rain water or…"
Do you dream about offshore cruising?
"hello
been years since on site.
im having trouble changing my heading. are we limited to words?
is there an instruction page?
Thank you
lola"
© 2025 Created by CAN DRAC.
Powered by
