"There's no circling on the 40/43 winches. It's simply a screw off collar. WD40 and a heavier hammer should get the job done."
SEAKNOTS FOUNDERS GO CRUISING FOR A CAUSE
Andrea and Franc, founders of SeaKnots, are finally full-time cruisers. They both put their day jobs on hold and decided to spend a year on the water for charity.
Their plan is to take S/V Can Drac across the second largest body of water in the world to raise awareness of the current water crisis on our planet. Sailing from New York to Barcelona will take them across more than 6,000 miles of the most remote waters in the Atlantic Ocean. Their initial goal is to raise one dollar for every mile to provide safe, clean drinking water for over 500 people in Africa.
Stay tuned to Can Drac's page for updates and click the button below to make your donation. You can even subscribe to Can Drac's blog!
Comment
-
Comment by Larry Wilson on January 23, 2009 at 8:41pm -
Good on ya!!!! Wish it were me!!!
Fair Winds
Latest Activity
Mike Brown replied to Wayne's discussion Jammed Electric Cabin Top Winch in the group Beneteau 40 & 43
Bruce Bogdanoff replied to Wayne's discussion Jammed Electric Cabin Top Winch in the group Beneteau 40 & 43"Mike is correct. The is a vertical pin in the middle of the winch handle hole that pushed down and disengages the electric motor on the winch. Also, on my Oceanis 45, there is a circlip that holds the top on. I don't remember if the 40 electric…"
Wayne replied to Wayne's discussion Jammed Electric Cabin Top Winch in the group Beneteau 40 & 43"Thanks Mike. I did use a light hammer but I do have heavier ones at work and I did use WD40. As for a disengagement pin, I didn't see one when I looked down in the top of the winch. I did see a small circular pattern in the bottom that I…"
Frank & Donna left a comment for Mike Brown"Thanks Mike, however I have tightened both attachments and if you grab the track in the middle you can move it side to side making the noise. I took it apart, slid the track forward to add tape to both side of the boom, than careful slid the track…"
Mike Brown left a comment for Frank & Donna"Frank your comment didn't show up in the discussions on the 40/43 site. It's simply a comment on your page. Not sure if others will see it. For what it's worth I don't have the problem on our boat. There are two pieces of…"
Mike Brown replied to Wayne's discussion Jammed Electric Cabin Top Winch in the group Beneteau 40 & 43"I can't imagine anything in the winch top that would bend. Other than the electric drive and a disengagement pin that activates when the winch handle is inserted the winch is the same as the others. It sounds like the collar is jammed due to…"
Wayne added a discussion to the group Beneteau 40 & 43
Jammed Electric Cabin Top Winch
Took care of the lint build up on the fridge condensers and the leaky shower sump this weekend. Then went to the electric cabin top winch to disassemble, clean and lube only to find the top cap wouldn't unscrew. It should have by light tapping with a screwdriver but to no avail.So I stepped it up a notch with a brass drift and screwdriver and again, no go. I then tried a steel drift and the cap never moved in the slightest. It is as if it was secured with permanent Lock Tite.Now when I say its…See More
Frank & Donna commented on CAN DRAC's group Beneteau 40 & 43"I'm having a knocking from the boom while sailing. The track on top of the boom is loose, but it can't be tightened any further. Has anyone else had this problem, if so has anyone found a solution"
© 2017 Created by CAN DRAC.
Powered by
You need to be a member of SeaKnots to add comments!
Join SeaKnots