"Michael,
From experience over three keel boats a fully battened main is almost a requirement.
Not only will it make dropping the sail into the boom bag far easier it certainly reduces any flogging and vastly lengthens the life of the sail. While…"
Claude's Discussions (3)
| Discussions Replied To (3) | Replies | Latest Activity |
|---|---|---|
"Didn't know if you'd seen this site.. Has the YSE manual to download. Good luck! htt…"Claude replied Dec 14, 2009 to Need help for a sick engine, |
16 |
Dec 28, 2009 Reply by PCarrico |
"Ohhhhhh .. close to the box is hard to solder onto.. The two tubes are co-axial ther…"Claude replied Nov 28, 2008 to Adler Barbour Evaporator 6"x10"x11" |
15 |
Apr 15, 2009 Reply by Randy |
"I have the same problem and have not fixed it yet.. I tried solder and epoxy and eve…"Claude replied Nov 20, 2008 to Adler Barbour Evaporator 6"x10"x11" |
15 |
Apr 15, 2009 Reply by Randy |
Latest Activity
"Hi All,
french built 2010 43 has been very dry down below but now a slow leak has occurred which is showing at the limber holes under the floor board in forward cabin. Bilge pump goes every 3hrs for 20secs. Not sure if it’s fresh/rain water or…"
Do you dream about offshore cruising?
"hello
been years since on site.
im having trouble changing my heading. are we limited to words?
is there an instruction page?
Thank you
lola"
© 2025 Created by CAN DRAC.
Powered by
