Adler Barbour Evaporator 6"x10"x11"
I need an Adler Barbour R12 evaporator box 6"x10"x11" to replace mine. I punctured it! The compressor (Danfoss Cold Machine) was working fine. It lost all pressure, so I will have to refill and pull a vacume. I have researched epoxy and/or brazing repair as an option, but have been told that doesn't work well. So, I am hoping to locate a used unit to reconnect to my compressor. Any possibilities and/or suggestions from any similar experiences would be appreciated.
- Attachments:
-
-
68427701813_0_SM.jpg, 2 KB -
22645701813_0_SM.jpg, 3 KB
-
Replies to This Discussion
-
Permalink Reply by Randy on
-
Here is a tip for everyone that did what I did with a knife as I punctured the evaporator on our Catalina 36 5 years ago and is still working today, The evap is very thin aluminum and will not take heat or silver solder cuz it will just melt the evap. What you can do is go to Grainger supply and get what is called RED EPOXY if they still carry it, it is made just for this, It is heat activated.
Here is a link to what I used and explains it more in detail.
http://www.highsidechem.com/redepxy.html
Randy Sherwood
- ‹ Previous
- 1
- 2
- Next ›
Latest Activity
SWITH FOR FORE AND AFT HEADS PUMPS
Our Oceanis 43 was recently serviced and since her return neither of the heads macerators are working. There must be a master switch located on board, trouble is I cannot locate it. Any assistance most welcome.BilgolabandsSee More
"Still active and always useful "
"Have a 2010 43 and whilst racing recently and well heeled over on port had similar experience. Only in the aft heads and haven’t as yet sorted out where the ingress came from but suspect the shower drain. Never happened before in 15 years with…"
IS SEAKNOTS BENETEAU 40/43 ACTIVE.
I note there has been no activity on SeaKnots Beneteau 40/43 since early 2025.Is one of my favourite boating sites still alive and kicking?BilgolabandsSee More
© 2026 Created by CAN DRAC.
Powered by
