SeaKnots

I had an exciting couple of hours on Friday when sailing.  The boat was on starboard and sailing at 8+Knots, when went below and stepped into the cabin the water was up to the floorboards   A check of all of the thru hull fittings revealed all was well so turned for home and the nearest travel lift.  Once we were on an even keel the water level started to go down and a crew member on the manual pump provided extra capacity.

Once back on the dock  ( next to the travel lift) I started to investigate and when the 46 is on starboard the outlets for the bilge and shower bilge are underwater.  My boat has an anti-siphon loop in the pipe but no valve so water was coming back in through the shower bilge outlet.

Has anyone else experience this with the Oceanis?   I am going to fit anti-siphon valve and bilge alarm in any case but I think it should have been something the manufacturer shoul have accounted for.  If we had been on starboard for another 30-40 minutes the water would have flooded my battery banks and then we would have had a serious problem.

Views: 968

Replies to This Discussion

We have a 2008 43 and fortunately have not seen your issue. Bet that hit the max on your pucker scale though.

Mike

It was an exciting few hours to say the least.  Fortunate in that i was only 3-4 miles offshore and knew there was a travellift I could (hopefully) get to.   The dealer has sent an inquiry to Beneteau so if we get a reply I will post it here.

Stephen I had one other source of water in the bilge from the AC unit in the salon. While there is a condensation pump the overflow tube would sometimes dumb water into the bilge. Unfortunately the hose was rather short and dumped it in the bilge compartment next to the mast post. I added a length of hose and routed it to the bilge sump. Another source of water at the AC unit can result if the compressor ices up. It can happen if there's not enough air flow through the duct work. Turning on the heat melts it quickly but the water drips off the compressor missing the catch pan. It finds it was through the floor boards into the same compartment I mentioned above.

Mike

RSS

Latest Activity

Brandon P is now a member of SeaKnots
Apr 18
Pankaj Tripathi is now a member of SeaKnots
Mar 19
Anna Kokou updated their profile
Mar 8
Profile IconDo My Assignment, William Noah, Thinq Proto and 4 more joined SeaKnots
Mar 7
Michael Boyle commented on CAN DRAC's group Beneteau 40 & 43
"Hi All, french built 2010 43 has been very dry down below but now a slow leak has occurred which is showing at the limber holes under the floor board in forward cabin. Bilge pump goes every 3hrs for 20secs. Not sure if it’s fresh/rain water or…"
Feb 28
LOLA commented on Franc's video
Thumbnail

Do you dream about offshore cruising?

"hello been years since on site. im having trouble changing my heading. are we limited to words? is there an instruction page? Thank you lola"
Jan 23
Filling Machine updated their profile
Dec 27, 2024
Packaging Machinery updated their profile
Dec 24, 2024
ADVERTISE ON SEAKNOTS CONTACT US AT: 
candrac@sailforwater.com

© 2025   Created by CAN DRAC.   Powered by

Badges  |  Report an Issue  |  Terms of Service