Deoxidize Fibergalss and all Metals with the same product

Check out Prism Polish and Mirage Sealant and Protectant - www.mppros.com

I have used Prism on everything from my boat to my sterling silver with great results.

Mirage is a much easier protection for fiberglass than wax. I get a whole sailing season on my boat and longer on my suburban.

0 members like this

▶ Reply to This

Replies to This Discussion

Permalink Reply by Bob Leahey on June 25, 2008 at 5:58pm

I'll agree with you on the Prism Polish. Great product. Though, I haven't tried it on fibreglass...yet! I did use some on the "plexiglass"(Not sure if plexi,lexan, etc.) covers over the cockpit instruments that were pretty cloudy and it did well to clear those up....have no experience with the Mirage sealant.

▶ Reply

Permalink Reply by Lynn on June 26, 2008 at 4:46pm

Since you had good results from Prism Polish, you should try Mirage.

▶ Reply

Permalink Reply by Lynn on June 28, 2008 at 6:48pm

I have had great results with Mirage - wash your boat with soap and a couple cups of amonia - the amonia will disolve any old wax - where it is chalky use Prism and a paper towel - then put two coats of Mirage. Every six months wash your boat and apply Mirage. You will never have to deoxidize your boat again. Try it on a small section - WHAT HAVE YOU GOT TO LOOSE???