Deoxidize Fibergalss and all Metals with the same product
Check out Prism Polish and Mirage Sealant and Protectant - www.mppros.com
I have used Prism on everything from my boat to my sterling silver with great results.
Mirage is a much easier protection for fiberglass than wax. I get a whole sailing season on my boat and longer on my suburban.
I have used Prism on everything from my boat to my sterling silver with great results.
Mirage is a much easier protection for fiberglass than wax. I get a whole sailing season on my boat and longer on my suburban.
Replies to This Discussion
-
Permalink Reply by Bob Leahey on
-
I'll agree with you on the Prism Polish. Great product. Though, I haven't tried it on fibreglass...yet! I did use some on the "plexiglass"(Not sure if plexi,lexan, etc.) covers over the cockpit instruments that were pretty cloudy and it did well to clear those up....have no experience with the Mirage sealant.
-
Permalink Reply by Lynn on
-
I have had great results with Mirage - wash your boat with soap and a couple cups of amonia - the amonia will disolve any old wax - where it is chalky use Prism and a paper towel - then put two coats of Mirage. Every six months wash your boat and apply Mirage. You will never have to deoxidize your boat again. Try it on a small section - WHAT HAVE YOU GOT TO LOOSE???
Latest Activity
"Hi All,
french built 2010 43 has been very dry down below but now a slow leak has occurred which is showing at the limber holes under the floor board in forward cabin. Bilge pump goes every 3hrs for 20secs. Not sure if it’s fresh/rain water or…"
Do you dream about offshore cruising?
"hello
been years since on site.
im having trouble changing my heading. are we limited to words?
is there an instruction page?
Thank you
lola"
© 2025 Created by CAN DRAC.
Powered by
