SeaKnots

Well, after 9 years the boat was beginning to gain a heady aroma. The head hoses were permeated and an inquiring nose could tell. So, changed out all hoses in the aft (most used) head .

Look at the picture of the hose from the y valve to the holding tank. It is the one that holds stuff due to the holding tank being high.

It weighed significantly more than the others upon removal. Now i see why. Probably would have clogged shut during some dark and stormy night, or at the most beautiful anchorage. Only about a half to three quarter inch opening remained.

Views: 117

Attachments:

Replies to This Discussion

Hi Sam

Thanks for the photo. Our boat is also 9 years old but so far so good, no smells. My question for you is;

 Are you using seawater or, on board fresh-water ( from tank) for flushing?

We installed a Jabsco fresh water flush system on our boat upon delivery and whenever I change joker valves I look/check hoses, so far, as far as I can see, they look clear and flush time seems consistent. We were lead to believe the smelling/blocking of lines is cause by deceased microbiological sea critter buildup in lines, not human waste. I have not checked the line from the Y valve to date. Additionally, if its human waste block up I would think clearing the lines might be a possibility since human waste should break up/dissolve fairly easily?

James

James, we use saltwater when offshore. Otherwise we use a freshwater flush. The design is such that whatever is in the line sits between the top of the holding tank and the joker valve. Over time, stuff builds up. Amazed at what a human can produce! Calcified urine, etc. 

Sam

Thanks for reply. Salt water + urine = calcification along with dead seacritter buildup/blockage equates to blocked pipes!
Even though our B43 has never flushed seawater I maintained original equipment in place but totally disconnected (thru hull shut off and lines blocked, pumps etc) to convert back to seawater flush in event of failure of freshwater flush but in 9 years of operation both electric heads have worked flawlessly.

Sam, wow that's some serious blockage. Like James we too flush with fresh water. And like James haven't had any issues with hose blockage (that we know of) or odor. Actually we find our biggest source of odor in the heads come from the sink/shower sump. We flush them on a regular basis or when they begin to stink. It's amazing the gunk that sticks to the inside of that drain hose and the odor it creates.

Mike

Agree that te shower drains really hold odors. I've found adding some bilge cleaner to the shower sumps and letting it sit helps

Sam

I think I'm going to plumb the sink drains directly overboard to remedy the problem. We use fresh water flush and the sea water intake seacock sits closed and unused. While I'll have to step the 1" drain hose down to the 3/4" sea water intake hose I don't see why it wont work. I may need to install a vented loop to prevent back flow while sailing but that should be easy enough. Just tired of the constant effort it takes to keep the sump from smelling. Plus no more drain sump cycling means less wear and tear on the pump.

Mike

Mike

In that config will you need some type actuated pump to pump your sinks drain water up through the vented loop before leaving boat? How would you configure the pump?

James, the vented loop should act just like a trap does under your sink at home so no need for a pump.

Mike

RSS

Latest Activity

Peter Obetz replied to Christopher Gaver's discussion Single bilge pump and standing water in engine compartment in the group Beneteau 40 & 43
"for what is worth, just make sure that the antifreeze you are seeing is from a spill with winerization process.  I noticed some in the same place on our 2008.  I chalked it up to possibly overfilling the antifreeze, however it occurred…"
Monday
Christopher Gaver replied to Christopher Gaver's discussion Single bilge pump and standing water in engine compartment in the group Beneteau 40 & 43
"Bruce/Mike - thank you very much for the responses... I needed a 'reason' for the lack of the bilge pump and what you said makes complete sense.  This should take some of the urgency out of the surveyor's…"
Monday
Anthony Luke Nelson updated their profile
Monday
Mike Brown replied to Christopher Gaver's discussion Single bilge pump and standing water in engine compartment in the group Beneteau 40 & 43
"Chris, the 43 is a great boat and I'm sure you'll enjoy it should you finalize the purchase. As you took notice of the sump below the engine does not drain to the bilge. My understanding is that it's designed that way so as to prevent…"
Monday
Bruce Bogdanoff replied to Christopher Gaver's discussion Single bilge pump and standing water in engine compartment in the group Beneteau 40 & 43
"The boat has two bilge pumps, one electric and one manual. On my 40, I replaced the original pump with a Rule 2000 and a check valve. The original pump would always lose its prime. The engine bilge does not drain into the main bilge in case of an…"
Monday
Christopher Gaver added a discussion to the group Beneteau 40 & 43
Thumbnail

Single bilge pump and standing water in engine compartment

I'm brand new to this group and almost a new owner of a 2008 Beneteau 43.  I have spent time reading nearly every discussion and post in this group in preparation for making the offer and understanding the boat.  It is clear that this group is extremely knowledgeable and willing to help.  I hope I don't overstay my welcome with questions...Here is my first one and it came up during the pre-purchase survey.  The boat had antifreeze (winterization/pink) in the bilge beneath the engine and then it…See More
Sunday
Christopher Gaver joined CAN DRAC's group
Thumbnail

Beneteau 40 & 43

A place to exchange thoughts, ideas and discussions about the Beneteau/Oceanis 40 and 43 models.
Sunday
Captain Conrad joined CAN DRAC's group
Sunday
ADVERTISE ON SEAKNOTS CONTACT US AT: 
candrac@sailforwater.com

© 2017   Created by CAN DRAC.   Powered by

Badges  |  Report an Issue  |  Terms of Service