SeaKnots

I had an exciting couple of hours on Friday when sailing.  The boat was on starboard and sailing at 8+Knots, when went below and stepped into the cabin the water was up to the floorboards   A check of all of the thru hull fittings revealed all was well so turned for home and the nearest travel lift.  Once we were on an even keel the water level started to go down and a crew member on the manual pump provided extra capacity.

Once back on the dock  ( next to the travel lift) I started to investigate and when the 46 is on starboard the outlets for the bilge and shower bilge are underwater.  My boat has an anti-siphon loop in the pipe but no valve so water was coming back in through the shower bilge outlet.

Has anyone else experience this with the Oceanis?   I am going to fit anti-siphon valve and bilge alarm in any case but I think it should have been something the manufacturer shoul have accounted for.  If we had been on starboard for another 30-40 minutes the water would have flooded my battery banks and then we would have had a serious problem.

Views: 1036

Replies to This Discussion

We have a 2008 43 and fortunately have not seen your issue. Bet that hit the max on your pucker scale though.

Mike

It was an exciting few hours to say the least.  Fortunate in that i was only 3-4 miles offshore and knew there was a travellift I could (hopefully) get to.   The dealer has sent an inquiry to Beneteau so if we get a reply I will post it here.

Stephen I had one other source of water in the bilge from the AC unit in the salon. While there is a condensation pump the overflow tube would sometimes dumb water into the bilge. Unfortunately the hose was rather short and dumped it in the bilge compartment next to the mast post. I added a length of hose and routed it to the bilge sump. Another source of water at the AC unit can result if the compressor ices up. It can happen if there's not enough air flow through the duct work. Turning on the heat melts it quickly but the water drips off the compressor missing the catch pan. It finds it was through the floor boards into the same compartment I mentioned above.

Mike

Have a 2010 43 and whilst racing recently and well heeled over on port had similar experience. Only in the aft heads and haven’t as yet sorted out where the ingress came from but suspect the shower drain. Never happened before in 15 years with some heavy weather sailing and well heeled. It’s on the list of must do soon.

RSS

Latest Activity

Robert & Sandy posted a discussion

SWITH FOR FORE AND AFT HEADS PUMPS

Our Oceanis 43 was recently serviced and since her return neither of the heads macerators are working. There must be a master switch located on board, trouble is I cannot locate it. Any assistance most welcome.BilgolabandsSee More
yesterday
Michael Boyle replied to Robert & Sandy's discussion IS SEAKNOTS BENETEAU 40/43 ACTIVE. in the group Beneteau 40 & 43
"Still active and always useful "
Jun 11
Michael Boyle replied to Paul O' Kirwan's discussion Flooding due to Bilge pump Reverse Siphon in the group Beneteau 40 & 43
"Have a 2010 43 and whilst racing recently and well heeled over on port had similar experience. Only in the aft heads and haven’t as yet sorted out where the ingress came from but suspect the shower drain. Never happened before in 15 years with…"
Jun 11
Robert & Sandy added a discussion to the group Beneteau 40 & 43
Thumbnail

IS SEAKNOTS BENETEAU 40/43 ACTIVE.

I note there has been no activity on SeaKnots Beneteau 40/43 since early 2025.Is one of my favourite boating sites still alive and kicking?BilgolabandsSee More
Jun 10
Profile Iconfgdfgdf, phreich, reportotosite and 3 more joined SeaKnots
May 26
phreich liked S/V Compadre's group Cascade Owners Unite
Apr 28
johnyosin updated their profile
Mar 2
Profile IconYour Homify, Love Horoscope Daily, Manley NaquilBet and 7 more joined SeaKnots
Feb 24
ADVERTISE ON SEAKNOTS CONTACT US AT: 
candrac@sailforwater.com

© 2026   Created by CAN DRAC.   Powered by

Badges  |  Report an Issue  |  Terms of Service